Vanity Cabinet Model
Vanity Cabinet Model
The great thing about installing a vanity is that it hides the plumbing pipes and makes for easy instillation. For the simple instillation and maintenance, choose a cover with the sink and counter in one piece molding.
To begin, remove the old battery. (Note: Do not forget to turn off the water) If you have an old Sink wall, remove the trap and supply lines. Cut the caulk sealing the sink from the wall. In some models, you can simply pick them up and away. Others connected to the mounting brackets with screws, which can be oxidized. Use penetrating oil or cutting with a saw.
Then you have to install pipes in the cabinet. Install valves and a new drain line, making sure to cover the vanity cabinet and will not interfere with the sink.
If the cabinet back, measure and holes for the tubes. Slide the cabinet into place and level, in both directions, using shims if necessary. Anchorage to the wall screws into the wall stud.
Install the faucet, flexible supply lines, and erection of drain in the sink. Set the sink on top of the cabinet. Make sure it is centered with the backsplash pressed against the wall. Connect the receiver to vanity. Connect the drain trap and supply lines. Run a putty where the backsplash meets the wall.
Finally you must connect the pop-up of the Assembly. Insert the ball bar in the opening and secure with a nut. Slide the rod through the strap and secure with hairpin clip chain. Lower the bar pop-up through all of the key peak. Slide the fork strap and tighten slightly. Adjust the fork so that the cap seals when the bar is raised. Tighten the bolt and go. An easy upgrade that just added value to your room bathroom.
Tagged as:
bathroom,
todd,
vanity
Return to the top of
Vanity Cabinet Model